Mar 27, 2024 Leave a message

About steam turbine shaft holding

The first is an introduction to the shaft holding case.

Introduction to the case of shaft holding - there are generally five situations in which the main engine shaft holding factor occurs: 1. Generally occurs during hot shutdown, working conditions change, and improper adjustment; 2. The temperature and pressure of the shaft seal are low, and the sudden cooling causes local deformation of the steam seal. The dynamic and static gaps disappear; 3. Water enters the cylinder, causing the cylinder to cool and deform, causing the dynamic and static collisions; 4. The unit does not expand smoothly or over-expands, causing axial contact between the rotor and the stator; 5. The water flow in the cylinder is not smooth, causing the cylinder to move up and down. Large temperature difference deforms, movement and static collision.

For the ultra-supercritical 1000MW unit, the shaft seal steam supply start-up and backup steam source come from the auxiliary steam of the old plant. A collision occurred during a hot trip. During the idle running period of the steam turbine, the self-sealing switches to auxiliary steam supply. Due to the long steam source pipeline, the auxiliary steam supply temperature drops sharply. Subsequently, the shaft seal steam supply temperature also drops from 320°C to 180°C and remains at 180°C. Fluctuates between ~240℃.

After inspection, it was found that dynamic and static friction occurred at the shaft seal of the high-pressure cylinder of the unit. When the cranking speed slowly dropped from 54rpm to 45rpm, the shaft vibration of the No. 2 bearing increased to 93.7 μm, reaching a maximum of more than 130 μm. The oil film oil pressure of the No. 2 bearing was between 5~ Fluctuated between 6Mpa, and then after the shaft seal steam supply temperature increased to above 260°C for 3 hours, the vibration decreased to 47μm, and the turning speed rose back to 54rpm.

After the ultra-supercritical 660MW unit tripped in the hot state, it self-sealed and switched to auxiliary steam supply. The auxiliary steam supply temperature dropped from 285°C to 185°C within 1 minute, slowly recovered after half an hour, and finally returned to around 240°C and maintained this temperature. temperature.
During this process, the unit speed dropped from 3000rpm to 20rpm and switched to cranking, and then the cranking suddenly stopped. After on-site inspection, it was found that the end of the high-pressure cylinder shaft seal was stuck, causing a shaft holding accident.

The above two factories are relatively similar, both have sudden changes in shaft seal temperature.The temperature drops too quickly, causing the unit to shut down in a hot state.Grinding of moving and static parts or even shaft holding accidents may occur.

The ultra-supercritical 660MW unit was shut down due to large vibrations in turbine watts 1, 2, and 3, which caused the brakes to be opened manually, destroying the vacuum. The turbine speed dropped to 0 and the cranking was started. After running for 5 hours, the cranking tripped and the main shaft locked.

The high-pressure cylinder was uncovered and inspected, and it was found that problems such as deformation and deviation of the high-pressure inner cylinder, damage to the rotor blades and partitions, and debris accumulation due to metal friction were found. The temperature difference between the upper and lower half of the high-pressure inner cylinder has been greater than 50°C for more than 30 hours of trial operation.

The design of the sliding pin system of the high-pressure inner cylinder is unreasonable, which causes the inner cylinder to move upward too much during operation, causing the radial dynamic and static clearance at the lower part of the cylinder to become smaller. The hydrophobic design of the superimposed cylinder is unreasonable. There is no hydrophobic point set at the low point of the outer cylinder. The upper and lower cylinders The temperature difference is large and the cylinder deforms, causing dynamic and static collisions to produce metal deposits, resulting in shaft holding accidents.

Send Inquiry

whatsapp

Phone

E-mail

Inquiry